Home > Forums > Software User Forums > ANSYS > FLUENT > Fluent UDF and Scheme Programming

update monitors obligatery for dynamic mesh

Mark Forums Read

Reply

Search this Thread

October 12, 2015, 13:43	update monitors obligatery for dynamic mesh	#1
bia New Member nabaouia Join Date: Aug 2014 Posts: 14 Rep Power: 12	hi guys , my problem is to get the drag and lift coeffcient of a circular cylinder which is controlled by a synthetic jet so i have a part of the cylinder wich move sinusoidally due to an udf . i set this part as user defined function in the dynamic mesh setting . my question is when i run the calculation i get 2 figures of drag and lift which are completely different of those given when i run (preview meshing + update monitors) so the question is which set should i make is it run calcluation or preview meshing+update monitors ?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
[OpenFOAM] Paraview 3.98.0 does not update list of mesh regions	letzel	ParaView	6	April 19, 2021 15:57
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[snappyHexMesh] problems generating clean mesh	Christian_tt	OpenFOAM Meshing & Mesh Conversion	2	June 20, 2019 05:39
Star CCM Overset Mesh Error (Rotating Turbine)	thezack	Siemens	7	October 12, 2016 11:14

All times are GMT -4. The time now is 11:46.