|
[Sponsors] |
How to write UDF for change the boundary condition of velocity inlet to wall |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 14, 2024, 09:50 |
How to write UDF for change the boundary condition of velocity inlet to wall
|
#1 |
New Member
Osvaldo Garcia Merino
Join Date: Feb 2024
Posts: 1
Rep Power: 0 |
Hello everyone
I have a tube 3D with the face of inlet is divided in 2 faces because i need for the inicial of simualtion both faces be velocity inlet but after 10 seconds change the boundary contions for 1 face to be a wall no slip Could you help me give me an idea of the macro I should use? |
|
February 14, 2024, 15:55 |
|
#2 | |
Member
Sebi
Join Date: Mar 2019
Posts: 49
Rep Power: 7 |
Quote:
|
||
Tags |
ansys, udf, velocity |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
UDF: Change boundary condition. Velocity inlet to pressure inlet at time "t" | jpina | FLUENT | 10 | April 11, 2015 14:19 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |