[christophe06]

Hi,

I have defined a UDF for 3D Inlet temperature profil and it doesn't works anymore after a crash of fluent. My profil has become flat and I couldn't have good interpretation of all my UDF know. It's really a bad point because I need to give a report about these CFD results this week. I have writing the temperature profil as followed:

#include "udf.h"
"define domain_ID 2 //

enum{OC, NUM_OF_USED_UDM};

DEFINE_PROFILE(inlet_temp, t, i)
{
real x[ND_ND];
real r;
face_t f;
real Diameter = 6.e-2;
real T_max = 5.e3;
real T_max = 3.e2;
begin_f_loop(f, t)
{
F_CENTROID(x,f,t);
y = x[1];
z = x[2];
r = sqrt(pow(y,2)+pow(z,2));
F_PROFILE(f, t, i) = (T_max-T_paroi)*(1-pow(2.0*r/Diameter,2))+T_paroi;
}
end_f_loop(f, thread)
}