Problem with boundary type -- CFD Online Discussion Forums

October 10, 2005, 11:13	Problem with boundary type	#1
Shanti Guest Posts: n/a	Hi I am modelling a mould...in which the fluid is static..Can someone help me with what type of boundary type should be defined for such a fluid?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
Boundary condition setting for non-premixed combustion using reactingFoam	skyopener	OpenFOAM	0	May 23, 2010 22:55
pipe flow with heat transfer	Fabian	OpenFOAM	2	December 12, 2009 04:53
transient simulation of a rotating rectangle	icesniffer	CFX	1	August 8, 2009 07:25
New topic on same subject - Flow around race car	Tudor Miron	CFX	15	April 2, 2004 06:18

All times are GMT -4. The time now is 11:40.