|
[Sponsors] |
Turbulent flow over a blunt body Error Message |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 27, 2012, 16:31 |
Turbulent flow over a blunt body Error Message
|
#1 |
New Member
Join Date: Jul 2012
Posts: 2
Rep Power: 0 |
Hello,
I am creating a simulation that analyzes the turbulent flow around a body of aluminum that is at a certain temperature. The idea is that the air flow will cool the aluminum to a specific temperature. I'm using the following models: 1. Viscous-Reynolds Stress, Linear Pressure-Straine 2.Heat exchanger-on When i run my simulation it comes up with the following error: Divergence detected in AMG solver: temperature Any ideas on what i'm missing? I do have boundary conditions: velocity inlet and outflow with a specified mass flow value. All suggestions and opinions are welcome! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFX Treatment of Laminar and Turbulent Flows | Jade M | CFX | 18 | September 15, 2022 07:08 |
Turbulent flow in porous medium | Chander | CFX | 4 | January 17, 2017 09:50 |
reversed flow at pressure inlet and turbulent viscosity is limited.... | cfdiscool | FLUENT | 10 | June 10, 2015 06:15 |
Validating OF, turbulent flow over flat plate | Thilo | OpenFOAM Verification & Validation | 0 | July 3, 2012 05:29 |
turbulent flow using PHOENICS | Abdul Hafid | Main CFD Forum | 5 | November 3, 1998 11:25 |