|
[Sponsors] |
Initial and boundary conditions for heat transfer in a fluidized bed |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
Musango Lungu
Join Date: Dec 2011
Location: China
Posts: 73
Rep Power: 14 ![]() |
I am modeling heat transfer in a fluidized bed shown here with the initial conditions. However I am failing to obtain a temperature gradient in the bed and the simulation crashes after a few runs. Kindly help with suggestions for suitable initial conditions and how to set then in FLUENT.
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 05:45 |
transsonic nozzle with rhoSimpleFoam | Unseen | OpenFOAM Running, Solving & CFD | 8 | July 1, 2022 06:54 |
problem with Min/max rho | tH3f0rC3 | OpenFOAM | 8 | July 31, 2019 09:48 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |