 |
 |
 |
|
|
|
[Sponsors] | ||||
October 19, 2012, 08:59
|
Marine turbine
|
#1 |
|
New Member
Join Date: Nov 2011
Posts: 4
Rep Power: 14  |
Hi all
I am trying to do marine turbine simulation. it should be placed 1 meter under the sea level, therefore the water pressure should be around 1 bar. should i use operation condition to set 1 bar of water pressure or is there another way to set-up this condition? thanks in advance. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with torque output from a turbine simulation. | pa-dundas | FLUENT | 5 | July 17, 2022 05:27 |
| Boundary condition setting regarding turbine simulation using CFX | Lacerlacer | CFX | 11 | March 12, 2012 09:32 |
| 2D modelling of a Vertax marine turbine | Robreid | FLUENT | 6 | May 16, 2011 12:01 |
| lift and drag Marine Turbine | saclu | FLUENT | 0 | May 13, 2011 04:43 |
| Marine current turbine (meshing and stimulation help needed!!) | coolyihao | FLOW-3D | 0 | March 16, 2009 11:48 |
Threaded Mode
