|
[Sponsors] |
Ansys mesh for FLUENT software giving unrealistic results, while GAMBIT mesh is fine |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 30, 2012, 15:52 |
Ansys mesh for FLUENT software giving unrealistic results, while GAMBIT mesh is fine
|
#1 |
New Member
CFD User
Join Date: Nov 2012
Posts: 2
Rep Power: 0 |
I always used GAMBIT for pre-processing and FLUENT for solving and post-processing until now. I am now trying to move away from GAMBIT and instead use ANSYS mesh (the one available in WB) for meshing. For the same size and type of mesh, I see that the results are very unrealistic with the ANSYS mesh. I am unable to figure out what could be causing this. I imported the geometry file from NX into Ansys DM, selected all the bodies and combined them to form a multibody part, so, I am sure there is connectivity across bodies and I see that in the data. However, the results are very different from what I see with a GAMBIT mesh. I already got a validated model with the GAMBIT mesh. I would greatly appreciate if someone could assist me with this situation. Thanks.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit problems | Althea | FLUENT | 22 | January 4, 2017 03:19 |
exporting the modified mesh from ansys | dogo1234 | ANSYS Meshing & Geometry | 1 | September 5, 2013 11:08 |
importing mesh from Gambit and other software to ansys workbench | mortazavi | CFX | 12 | May 30, 2012 07:38 |
importing mesh from Gambit and other software to ansys workbench | mortazavi | ANSYS Meshing & Geometry | 5 | June 6, 2011 11:09 |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |