|
[Sponsors] |
K-E residual fluctuation in combustor analysis |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 23, 2013, 05:07 |
|
#3 |
Member
Thiagu
Join Date: Oct 2012
Location: India
Posts: 60
Rep Power: 13 |
Not SIMPLE , it is SIMPLEC . But no specific reason. Earlier analysis I tried with coupled algorithm but i found this SIMPLEC method shows faster convergence.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
High Courant Number @ icoFoam | Artex85 | OpenFOAM Running, Solving & CFD | 11 | February 16, 2017 13:40 |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |