|
[Sponsors] |
Slug flow modelling in vertical pipe using ansys software 12.1 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 5, 2013, 15:05 |
Slug flow modelling in vertical pipe using ansys software 12.1
|
#1 |
New Member
Eric Thompson
Join Date: Apr 2013
Posts: 2
Rep Power: 0 |
My name is Eric Thompson I am pursuing my masters in petroleum engineering at African University of Science and Technology. However, I am using anys software 12.1 in my thesis work to model slug flow using VOF model, but I am facing some challenges and stack up now, even though, I have set most of the parameters for VOF model.
pressure based solver Volume of fluid model K.e turbulence model phases- air and silicone oil Boundary conditions velocity inlet Outflow Wall Eventhough, the solution converges, I cant see the slugs been displaced in the contours. It seems l need some technical guide to overcome this challenge. I would be very grateful if ANYONE can assist me out to enable me finish my thesis work. Anyway this are my contacts: Facebook: Mawufemor Kwaseric Skype: kpesco1 Tel: +2348103880111. Email: kpesco_azigi@yahoo.com Hope to hear from you soon. Counting on your usual co-operation.I am left with two days to submit this thesis work. need urgent help. I will be very grateful for your assistance. Thank you Eric Thompson AUST |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blockage in pipe ( using solidwork flow simulation) | jchow | FloEFD, FloWorks & FloTHERM | 1 | January 16, 2012 16:03 |
Ansys 11.0 CFX - solving electric potentials and multiphase flow | cfd_multiphyiscs | CFX | 2 | March 10, 2010 13:43 |
modelling slug flow with pressure inlet | Azman | FLUENT | 0 | May 29, 2006 06:45 |
vertical pipe flow | Saud | Main CFD Forum | 0 | May 21, 2004 16:25 |
Vertical pipe flow | Saud | Main CFD Forum | 0 | May 21, 2004 16:13 |