|
[Sponsors] |
April 21, 2013, 08:51 |
how to reduce incomplete particles?
|
#1 |
Member
Tarantino
Join Date: Feb 2013
Posts: 46
Rep Power: 13 |
Hello all!
during particle tracking in my case, I got almost the whole release particles incomplete as you can see below: DPM Iteration .... number tracked = 60, escaped = 0, aborted = 0, trapped = 5, evaporated = 0, incomplete = 55, incomplete_parallel = 0 Parallel particle tracking concurrency: 21% I increase the max. Number of steps to reduce the incomplete as it recommended in user manual, but nothing change! Any suggestion in the case? |
|
April 21, 2013, 09:15 |
|
#2 |
Senior Member
Rick
Join Date: Oct 2010
Posts: 1,016
Rep Power: 26 |
If it is a cyclone application you can read this about incomplete particles tracking:
http://www.cfd-online.com/Forums/flu...imulation.html http://www.cfd-online.com/Forums/flu...e-cyclone.html This could be applied also to other models. Daniele |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Problems building Paraview 3.12 on Gentoo Linux | pajot | OpenFOAM Installation | 11 | April 11, 2013 08:09 |
[swak4Foam] installing funkySetFields | igo | OpenFOAM Community Contributions | 1 | November 20, 2012 20:16 |
incomplete particles in DPM model | elah599 | FLUENT | 1 | June 26, 2011 01:37 |
incomplete particles | jack | FLUENT | 2 | November 11, 2007 05:21 |