|
[Sponsors] |
April 30, 2013, 08:45 |
FLUENT boundary condition problem with gmsh
|
#1 |
New Member
E
Join Date: Apr 2013
Posts: 9
Rep Power: 13 |
Hello.
I created a meshed geometry using the software gmsh. I created physical zones in gmsh as zell so that I would be able to define boundary conditions in FLUENT. I saved the file as .bdf before importing it into FLUENT then saving it as a .cas file. The boundaries are shown in FLUENT but I am unable to edit the boundary conditions i.e no slip wall The FLUENT toolbox writes "This page is not applicable under the current settings" Is there any setting I can change in FLUENT so that I can edit the boundary conditions? Thank you I found a solution to this problem. I used ICEM to create the geometry instead. Last edited by EIvb; May 22, 2013 at 09:12. Reason: I have found a solution |
|
Tags |
boundary condition, fluent, gmsh |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 06:45 |
(Heattransfer) Temperature boundary condition problem | suitup | OpenFOAM Bugs | 15 | October 14, 2010 23:18 |
vorticity boundary condition | bearcharge | Main CFD Forum | 0 | May 14, 2010 12:32 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
a problem with Boundary condition | M Rad | Main CFD Forum | 12 | November 27, 1998 13:49 |