|
[Sponsors] |
May 17, 2013, 03:34 |
|
#14 |
Member
Join Date: Jul 2009
Posts: 70
Rep Power: 16 |
your simulation is 2D or 3D?
How is the geometry/mesh look like? How much y plus value for the mesh? Which turbulent model you used? and the setting parameters for the turbulent model? the boundary conditions... Thanks you very much! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Data for NACA 0012 | Muntazir | Main CFD Forum | 1 | March 28, 2023 01:59 |
How to import NACA 0012 Profile in Gridgen | maplepink | Main CFD Forum | 17 | May 7, 2013 13:01 |
[Other] Is my setup correct?I am trying to simulate flapping motion of the wing using Dynamic | cfd seeker | ANSYS Meshing & Geometry | 2 | September 13, 2012 06:02 |
Problems with flat plate and NACA 0012 Lift/Force | Harly | FLUENT | 0 | June 18, 2007 10:02 |
NACA 0012 simulation results | Luis | FLUENT | 3 | February 15, 2006 11:42 |