|
[Sponsors] |
June 21, 2013, 10:06 |
3D swirl combustion using tangential inlets
|
#1 |
New Member
P.Dev
Join Date: Jan 2012
Posts: 2
Rep Power: 0 |
i am simulating a 3D model of a burner. I created a 45 degree view geometry of the burner with periodic boundary conditions. i m using RSM model since i heard it is gud for a swirl no of 0.7. While solving for unsteady conditions, the results dont seem to match the experimental streamlines. I am not getting the axial recirculation at all...!!!wat do i do???is it because of the 45 degree model??? shud i model the full 360 deg view??? or shud i change the turbulence model to LES???
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ActuatorDiskExplicitForce in OF2.1. Help | be_inspired | OpenFOAM Programming & Development | 10 | September 14, 2018 11:12 |
Problem with time average tangential velocity in swirl flow. | lakhi | FLUENT | 5 | July 18, 2012 16:28 |
Coal Combustion Separate Inlets | Leepox | FLUENT | 5 | June 19, 2012 06:36 |
Tangential Inlets | Curious | CFX | 24 | February 24, 2012 06:10 |
Hydrogen combustion with swirl of coaxial air | Harikishan | FLUENT | 0 | December 18, 2002 07:46 |