 |
 |
 |
|
|
|
[Sponsors] | ||||
July 11, 2013, 12:23
|
Turbulence model in hypersonic flow
|
#1 |
|
New Member
Ajmal
Join Date: Jul 2013
Posts: 1
Rep Power: 0  |
I am solving flow on the cone at hypersonic speed but there are some problems in the results. so i want to help in following sections..
which turbulence model should be preferable?? what should be y+ to capture the boundary layer?? what should be the thermal conductivity to observe the temperature on the wall??? what should the value of Cp??? Should i use ideal gas??? Regards |
|
|
|
|
 |
| Tags |
| hypersonic flow, turbulence modeling, wall y+ |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbulence model for low Reynolds number flow? | Nokadu | Main CFD Forum | 3 | May 26, 2013 12:42 |
| Advice on turbulence model for complex internal flow | JPBodner | Main CFD Forum | 1 | September 3, 2011 04:07 |
| validating turbulence model on flow around a car | Pedro | CFX | 1 | February 20, 2008 17:32 |
| turbulence model for oil flow thr' small gap | carno | Siemens | 2 | August 31, 2005 09:12 |
| Turbulence Model for flow between corotating disk | Felipe | FLUENT | 0 | January 10, 2004 13:01 |
Linear Mode
