 |
 |
 |
|
|
|
[Sponsors] | ||||
How Can I create the mesh by using a quarter of mesh? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 29, 2013, 16:15
|
How Can I create the mesh by using a quarter of mesh?
|
#1 |
|
Senior Member
Sasan Ghomi
Join Date: Sep 2012
Location: Denmark
Posts: 292
Rep Power: 15  |
Hi friends,
I created a quarter of mesh in GAMBIT and afterwards I copied the mesh in Y and Z directions(reflect) I should say that I activated copy zone types and copy mesh linked. But after reading the mesh by fluent there were several new boundary (Wall) in geometry. Also I connected these faces in gambit and after reading the mesh by fluent I had several warnings same as : Warning: Reversing 15836 faces, zone 7. Please anybody say me how can I create whole the mesh by using a quarter of mesh in gambit. I appreciate any help from you, Thanks and best regards, Sasan. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gambit problems | Althea | FLUENT | 22 | January 4, 2017 03:19 |
| How to create a mesh use ICEM in CFX? | little stone | CFX | 3 | July 17, 2012 19:33 |
| [ICEM] Problem making structured mesh on a surface | froztbear | ANSYS Meshing & Geometry | 4 | November 10, 2011 08:52 |
| [ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
| Create fine mesh that grows to coarse mesh (Urgent | CZ | FLUENT | 1 | January 3, 2009 10:36 |
Linear Mode
