 |
 |
 |
|
|
|
[Sponsors] | ||||
Converge continuity residual for multiple geometries |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 11, 2019, 10:34
|
Converge continuity residual for multiple geometries
|
#1 |
|
New Member
Bruno Margotto
Join Date: Jun 2017
Posts: 5
Rep Power: 8  |
Hey, guys.
First, I have a simple geometry as shown on figure attached. I wan't to simulate 2 geometries in same case. Each geometry and respective mesh is the same. Therefore, I have 2 equal geometries and meshes at same case. But for each one, I have different inlet velocities. My problem here is the continuity residual that doesn't converge. Do you know how to solve this issue? Thanks in advance! |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| time step continuity problem in VAWT simulation | lpz_michele | OpenFOAM Running, Solving & CFD | 5 | February 22, 2018 19:50 |
| Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 11:08 |
| Cannot run the code properly: very large time step continuity error | crst15 | OpenFOAM Running, Solving & CFD | 9 | December 14, 2014 18:17 |
| How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |
Linear Mode
