|
[Sponsors] |
August 14, 2014, 09:53 |
DPM with boundary inflation layer
|
#1 |
Member
ben
Join Date: Apr 2013
Posts: 36
Rep Power: 13 |
Hello all,
I am using DPM and k-w SST turbulence model. The k-w SST turbulence model requires a very fine mesh at the boundary (yplus value <2). However if yplus value is very small, while doing particle tracking it not only takes a long time but also results incomplete tracking (8200 tracked & 6500 incomplete). So it seems small yplus value =? successful particle tracking. Can anyone help? Thanks, Richard |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Divide Prismatic Boundary Layer Mesh causes overlapping faces | SilentRunner42 | enGrid | 4 | May 4, 2015 03:37 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |