|
[Sponsors] |
August 28, 2014, 10:57 |
Angle of attack
|
#1 |
New Member
lavala srinivasarao
Join Date: Jul 2014
Posts: 9
Rep Power: 11 |
while doing ,i got problem in angle of attack
my body angle 20 and my velocity 20 m/s so x componentis 18.79 and y component is 6.84 i am little confused about this values. i ignore x component value or y component value please some body help me |
|
August 28, 2014, 23:31 |
|
#2 | |
Senior Member
Amin
Join Date: Oct 2013
Location: Germany
Posts: 397
Rep Power: 14 |
Quote:
You must enter these values in "component" tab or use "magnitude & direction" tab! |
||
August 29, 2014, 13:42 |
angle
|
#3 |
New Member
lavala srinivasarao
Join Date: Jul 2014
Posts: 9
Rep Power: 11 |
acutually my body inclined 20 angle of attack in gambit then done meshing, while doing in fluent x or y value which will give and in fluent three options are there 1. magnitude and direction
2.components 3.magnitude and normal boundary and which coordinate will neglect |
|
August 29, 2014, 14:38 |
|
#4 | |
Senior Member
Amin
Join Date: Oct 2013
Location: Germany
Posts: 397
Rep Power: 14 |
Quote:
You can select "magnitude and direction" then enter 18.79 & 6.84 for x & y respectively! |
||
August 30, 2014, 13:56 |
angle
|
#5 |
New Member
lavala srinivasarao
Join Date: Jul 2014
Posts: 9
Rep Power: 11 |
thank you sir
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFX convergence problem simulating ogive-cylinders at varied angle of attack | jdacosta | CFX | 6 | February 25, 2015 21:42 |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
introducing angle of attack on ICEMCFD HEXA | icem beginner | Main CFD Forum | 3 | December 17, 2008 05:05 |
angle of attack with icem hexa | icem beginner | Main CFD Forum | 0 | December 5, 2008 16:54 |
angle of attack | kiran | FLUENT | 0 | September 10, 2004 08:18 |