 |
 |
 |
|
|
|
[Sponsors] | ||||
October 6, 2014, 20:17
|
Boundary Conditions
|
#1 |
|
New Member
Emma
Join Date: Sep 2014
Posts: 2
Rep Power: 0  |
Hello!
I need help creating boundary conditions for a space capsule in subsonic and supersonic wind tunnels. On ICEM CFD, I've created a mesh for a capsule inside a fluid, and at the end, you have to apply boundary conditions before outputting it to Fluent. Can anyone help me out with this step? Thank you Emma |
|
|
|
|
|
October 7, 2014, 10:39
|
|
#2 |
|
Member
David Stanbridge
Join Date: Apr 2010
Location: Norwich, UK
Posts: 59
Rep Power: 16 |
Emma, You can also change the boundary conditions in Fluent so if you use a velocity inlet and a pressure outlet you can change them depending upon what you want from the simulation
|
|
|
|
|
|
 |
| Tags |
| boundary conditions, fluent, icem cfd |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| GETVAR Error in Multiband Monte Carlo Radiation Simulation with Directional Source | silvan | CFX | 3 | June 16, 2014 09:49 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
| [Netgen] boundary conditions and mesh exporting | vaina74 | OpenFOAM Meshing & Mesh Conversion | 2 | May 27, 2010 09:38 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Linear Mode
