|November 16, 2014, 06:24||
Boundaries for an arc-ringed rotation case
Join Date: Nov 2014
Posts: 6Rep Power: 4
I meet a case like this.I wanna simulate water flowing in a ringed domain around an axis.
-I used frame motion with rad/s=0.03(ignore the zone name"solid",the zone is water).
-inlet sets with velocity-inlet to only have a tangential componet with the rotation with 0.03 rad/s with udf(I set all the velocity with absolute definition).
-outlet sets with pressure outlet=0(averaged specification).
-k-omega(sst) as turbulence model.
1.why would the calculated velocity profile like this ,especially the cycled area.
I think the velocity mag should be in proportion to the radius(the velocity should ranged from 0.21 to 0.38m/s).
2.all the set up is shown,hope anyone can help me find out the improper ones.
Thank you so much and best wishes.
|boundary, frame motion, rotation|
|Thread||Thread Starter||Forum||Replies||Last Post|
|checkMesh for a Hollow Cylinder||hwsv07||OpenFOAM Native Meshers: blockMesh||8||November 13, 2014 14:40|
|3D Fan:Calculation of induced flow rate by fan rotation at free delivery||Catthan||FLUENT||3||November 6, 2013 06:19|
|multiregion mesh with blockMesh||alvora||OpenFOAM Native Meshers: blockMesh||44||July 21, 2013 14:14|
|Free surface boudary conditions with SOLA-VOF||Fan||Main CFD Forum||10||September 9, 2006 12:24|
|flow simulation across a small fan||jane luo||Main CFD Forum||15||April 12, 2004 17:49|