|
[Sponsors] |
Fan Simulation Mixing plane interface reversed flow |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
RacMat
Join Date: Jan 2013
Posts: 77
Rep Power: 12 ![]() |
Hi,
I have been using the the default interface option while simulating a rotor with inlet guide vanes and outlet guide vanes. I recently switched to the mixing plane model for the interface and this is giving me reversed flow at the interface of the rotor and the outlet guide vanes. I did not have such problem with the default interface. When i plot the contours at the interface i can see no reverse flow. Please help me out with this! Thanks! P.S. : Sorry i posted this in the main CFD forum :'( |
|
![]() |
![]() |
![]() |
Tags |
fan simulation, mixing plane model, mrf, turbomachinery |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 06:40 |
Convergence of jet flow simulation | MiraLisa | FLUENT | 0 | August 15, 2013 04:44 |
Air flow simulation in volume with fan and opening | koziymf | FLUENT | 0 | November 14, 2011 17:44 |
flow simulation across a small fan | jane luo | Main CFD Forum | 15 | April 12, 2004 17:49 |
Question concerning about the flow simulation of a fan in an engine room. | ghlee | Main CFD Forum | 3 | October 21, 1998 07:05 |