Strange lines on the control volume in fluent

aleix.de.toro · January 22, 2015, 10:50

I am simulating a 3d profile on fluent, when the mesh is uploaded on fluent it appears an strange line from the extrados to the intrados of the wing.

The pictures shows the line in a 2d plane, it occurs on the whole control volume 3d.

Do you know what does it means? maybe a bad meshing?

I have over 3 million elements, but im getting bad results, what models do you use in that cases ?

Many thanks in advance!

ghost82 · January 22, 2015, 11:03

I think you are running a parallel simulation and the "line" you see is the partitioning line, so no problem.
Do a mesh check to see if everything is ok.

Daniele

aleix.de.toro · January 22, 2015, 18:45

Thanks Daniele!

One more think, I suppose the use of parallel simulation (when i choose the processes on fluent) is to put how many the cores my computers uses, so it goes faster but does not affect on the results isn't it?

Many thanks!!

ghost82 · January 23, 2015, 05:24

Yes, the number of cores doesn't influence results; for other problems, if any, check carefully your boundary conditions and your mesh.

January 22, 2015, 11:03		#2
ghost82 Senior Member Rick Join Date: Oct 2010 Posts: 1,016 Rep Power: 26	I think you are running a parallel simulation and the "line" you see is the partitioning line, so no problem. Do a mesh check to see if everything is ok. Daniele __________________ Google is your friend and the same for the search button!

January 23, 2015, 05:24		#4
ghost82 Senior Member Rick Join Date: Oct 2010 Posts: 1,016 Rep Power: 26	Yes, the number of cores doesn't influence results; for other problems, if any, check carefully your boundary conditions and your mesh. __________________ Google is your friend and the same for the search button!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] mesh airfoil NACA0012	anand_30	OpenFOAM Meshing & Mesh Conversion	13	March 7, 2022 17:22
Fluent Non-Positive Volume	eishinsnsayshin	FLUENT	1	April 9, 2012 07:21
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
air bubble is disappear increasing time using vof	xujjun	CFX	9	June 9, 2009 07:59
control volume	leo	FLUENT	0	November 1, 2007 09:54

January 22, 2015, 18:45		#3
aleix.de.toro New Member aleix de toro diaz Join Date: Dec 2014 Posts: 9 Rep Power: 11	Thanks Daniele! One more think, I suppose the use of parallel simulation (when i choose the processes on fluent) is to put how many the cores my computers uses, so it goes faster but does not affect on the results isn't it? Many thanks!!