|
[Sponsors] |
problems setting up heat transfer between plates - what is wrong with this? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
May 10, 2015, 16:33 |
problems setting up heat transfer between plates - what is wrong with this?
|
#1 |
Member
cglr
Join Date: Apr 2015
Posts: 31
Rep Power: 11 |
Hello,
I have two parallel plates and 40 mm distance between them. Air blows at two sides(left and right) of this gap. Plates have higher temperature than the initial air temp. I utilized kw-sst model with boussinesq. I need to observe heat transfer coefficient between air and plates in the end. But strangely when postprocessing, I see heat transfer coefficient contours for a plate in one color(third attachment). what is wrong about it ? note: second attachment shows velocity vectors for middle plane. (y+ is 3,4) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Radiation heat transfer boundary condition | natrask | OpenFOAM Programming & Development | 0 | February 8, 2015 09:05 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
Heat Transfer Between two Plates | neilth | CFX | 1 | July 10, 2011 06:34 |
Setting data for heat transfer coefficient | Miguel | CFX | 2 | January 8, 2009 16:00 |
heat transfer in conjugate heat problems | cirilo | Siemens | 1 | April 18, 2006 09:16 |