[Phani Vivek]

Hi everyone,

I'm new to ANSYS Fluent. Looking for guidance in solving problem for my thesis.

I've got the geometry model of a centrifugal pump and I'm trying to plot the flow field simulation.

I've been through many tutorials in YouTube on this problem and the one which is most suitable for my problem is this
PART-1"https://www.youtube.com/watch?v=PN0NWz_1SI8&index=16&list=PL2AsOgDm3Nd-WsIIx4seAW-yTFFcpbtAB"
PART-2"https://www.youtube.com/watch?v=0rJB-IT81p0"

I've the following operating variables values: 1)mass flow rate 2)suction pressure 3)delivery head 4)RPM and 5)NPSH
What are the inlet and outlet boundary conditions that should be taken for best and accurate result with the values I've?

Regards.