|
[Sponsors] |
September 15, 2015, 07:54 |
Fluent changes upstream specifics
|
#1 |
Member
Shaheer
Join Date: Jul 2015
Posts: 37
Rep Power: 10 |
Hello I am modeling heat transfer between to close objects in a fluid zone. Now i form the geometry and mesh using workbench but when i go to fluent it changes some of the stuffs which adversely effect the solution, like the contact zones are often merged so that i get there is an issue with both having interface overlaping hence giving 2 of the objects 2 solid properties become problematic, also i get message like fluent has changed the mesh.
How to deal with that? Any one tried to model conduction system in an environment with flowing air before? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
heat transfer with RANS wall function, over a flat plate (validation with fluent) | bruce | OpenFOAM Running, Solving & CFD | 6 | January 20, 2017 06:22 |
Fluent 12.0 is worst then Fluent 6.2 | herntan | FLUENT | 5 | December 14, 2009 02:57 |
Is C0 the upstream cell in Fluent? | bigfans | FLUENT | 0 | October 30, 2009 10:31 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |