|October 7, 2015, 09:42||
Problem in dynamic meshing
Join Date: Apr 2014
Posts: 45Rep Power: 4
I am doing peristaltic flow analysis in a 2D channel. In this simulation a sinusoidal wave is propagated at the channel upper wall as shown in the attached image. For this purpose a UDF is used. When I compile the UDF and set up dynamic meshing for the given flow field, I can't see any wall motion at all. I have tried smoothing layering and remeshing with different combinations as suggested in ANSYS fluent user's guide and here on this forum. But I am unable tp see any deformation/motion of the wall.
I don't know whether it is a problem in my UDF or I am not properly setting up the dynamic meshing.
I am desperately in need of any useful suggestions.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem with querying the meshing database in CFX-Pre||ashtonJ||CFX||16||November 23, 2016 04:56|
|[ICEM] Meshing Problem ?||Leifheit||ANSYS Meshing & Geometry||3||December 4, 2014 19:09|
|UDF for dynamic meshing?||prasaddeole||FLUENT||2||October 6, 2014 11:55|
|Gambit - meshing over airfoil wrapping (?) problem||JFDC||FLUENT||1||July 11, 2011 05:59|
|Dynamic meshing||Manoj Kumar||FLUENT||3||June 27, 2010 19:26|