 |
 |
 |
|
|
|
[Sponsors] | ||||
Simulation of flow around a ship hull using fluent and Openfoam |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 17, 2015, 02:05
|
Simulation of flow around a ship hull using fluent and Openfoam
|
#1 |
|
Member
Manoj
Join Date: Jun 2013
Posts: 38
Rep Power: 14  |
Hi All,
I am trying to simulated flow around a ship hull (half hull), referring to the example DTCHull. I have generated the mesh using snappy. The same mesh I have also exported to Fluent format. I have run exactly similar simulation in OpenFoam and Fluent and I found that the pressure resistance calculated using openfoam is almost half that of Fluent calculated value. Can anyone help me to know, why is it so. Am I making any mistake? Has anyone faced a similar problem.. Regards, Manoj |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Periodic flow using Cyclic - comparison with Fluent | nusivares | OpenFOAM Running, Solving & CFD | 30 | December 12, 2017 06:35 |
| Resistance calculation for flow around a ship hull | manoj_nav | OpenFOAM Running, Solving & CFD | 0 | December 17, 2015 02:03 |
| OpenFoam Airfoil simulation - replacing Fluent with OpenFOAM | shereez234 | OpenFOAM Running, Solving & CFD | 1 | November 3, 2015 04:54 |
| Question on transient simulation in OpenFOAM and FLUENT | nicklj | OpenFOAM Running, Solving & CFD | 4 | May 8, 2014 23:30 |
| FLUENT or OpenFoam for Particle-surface intercation simulation? | Amir1 | Main CFD Forum | 0 | May 10, 2013 18:15 |
Linear Mode
