|
[Sponsors] |
February 14, 2016, 19:11 |
summing phases in a VOF analysis
|
#1 |
New Member
Join Date: Mar 2014
Posts: 20
Rep Power: 12 |
Hi,
I was wondering if there is any way to sum the amount of a specific phase that went through an outlet in a VOF analysis. I will try to explain. I have a VOF analysis with 2 phases (lets say air and water), there are: 1 inlet and 2 outlets. after a given time (completion of analysis) a certain amount of one of the phases (lets say water for example) has left the domain (trough one - or both of the outlets). Is there a way to sum up the total amount of the water phase that went through each of the outlets? Thanks. |
|
February 15, 2016, 00:05 |
|
#2 |
Senior Member
Join Date: Mar 2014
Posts: 375
Rep Power: 13 |
results->fluxes
select the phase and mark the inlet/outlet etc, you will get the mass flux imbalance and all you are looking for... |
|
February 23, 2016, 16:11 |
|
#3 |
New Member
Join Date: Mar 2014
Posts: 20
Rep Power: 12 |
Thanks for your reply.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Time dependent accelerations and angular accelerations in VOF analysis | sture | OpenFOAM Pre-Processing | 0 | December 12, 2013 11:23 |
Explicit method for more than two phases | sachinthakre | FLUENT | 1 | February 17, 2011 12:07 |
VOF analysis help needed... | Leo | FLUENT | 4 | March 28, 2003 05:31 |
Moving mesh or VOF? | Giovanni | Main CFD Forum | 16 | September 24, 2001 08:25 |
Is CFD Science or Art ? | John C. Chien | Main CFD Forum | 36 | October 5, 1999 12:58 |