|
[Sponsors] |
Problem in temperature distribution in Ansys Fluent |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 6, 2016, 14:05 |
Problem in temperature distribution in Ansys Fluent
|
#1 |
New Member
Ali Riaz
Join Date: Mar 2016
Location: Pakistan
Posts: 22
Rep Power: 10 |
Hi everyone;
I am using ANSYS 16.0 FLUENT module to study natural convection phenomena inside the casing. But there is a problem in temperature distribution while examining results i.e. temperature close to heater is low and away from heater is high. I have few questions beside this problem please adress them; 1.How to apply boussinesq approximation in fluent 2.How to draw nusselt number along the wall This is the modeling in ansys; Point close to heater (cube) has low temperature while point away from heater has high temperature,, Capture.PNG Suggestions are warmly welcomed; Please share the link of any guide or tutorial related to natural convection study in ansys fluent 16.0 |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[openSmoke] libOpenSMOKE | Tobi | OpenFOAM Community Contributions | 562 | January 25, 2023 10:21 |
[ANSYS Meshing] Fluent Conjugate heat transfer: Temperature at a small fluid region exceed limit | RPjack | ANSYS Meshing & Geometry | 1 | June 20, 2019 08:11 |
Help Needed for very simple problem {ANSYS Fluent} | naikaj | FLUENT | 2 | March 13, 2014 01:35 |
Fluent Ansys temperature coupling | tensun | FLUENT | 0 | November 14, 2010 06:31 |
Fluent Ansys temperature coupling | tensun | Fluent UDF and Scheme Programming | 0 | November 14, 2010 06:30 |