|
[Sponsors] |
[ERROR] The mesher cannot find matching topology |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 24, 2018, 04:04 |
[ERROR] The mesher cannot find matching topology
|
#1 |
New Member
Ash
Join Date: Dec 2017
Posts: 1
Rep Power: 0 |
Hi, I'm still new to ANSYS. I'm currrently doing my project by using ANSYS R15.0 Fluent.
I've done the geometry in DM, but after proceeding to the Mesher, when I try to match control the surface of inlet and outlet in order to make both surfaces' boundary condition as cyclic later, an error appeared stating "The mesher cannot find matching topology for the following topology. Please verify that the topology is the same shape & size. Also verify the position and orientation of any associated coordinate systems." Am I missing something ? Here I attached the screenshot showing the failed mesh. Thanks for your help! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFX problem in ubuntu (linux) | Vigneshramaero | CFX | 0 | July 13, 2012 10:22 |
CFX-Pre problem, pls help!!! | cth_yao | CFX | 0 | February 17, 2012 00:52 |
OpenFOAM 1.6-ext git installation on Ubuntu 11.10 x64 | Attesz | OpenFOAM Installation | 45 | January 13, 2012 12:38 |
Problem Building OF on Centos cluster (no admin rights) | CKH | OpenFOAM Installation | 5 | November 13, 2011 06:32 |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |