|
[Sponsors] |
July 27, 2016, 14:11 |
questions about ddpm
|
#1 |
New Member
Jas
Join Date: Dec 2010
Posts: 12
Rep Power: 15 |
Hi,
I want to specify the drag coefficients of particles in DDPM model. However, I want to do this based on the property of individual particle instead of the solid phase of the cell, as my particles have different sphericity. I try to use DEFINE_DPM_DRAG to do this. But it has some problems when I click calculte: received a fatal signal (Segmentation fault). Of course, if I only use dpm model, the calculation could continue. We could only use DEFINE_EXCHANGE_PROPERTY to change the drag coefficient? Could you give me some suggestions? THank you very much. Best wishes, socreate |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Frequently Asked Questions about Installing OpenFOAM | wyldckat | OpenFOAM Installation | 3 | November 14, 2023 11:58 |
Map of the OpenFOAM Forum - Understanding where to post your questions! | wyldckat | OpenFOAM | 10 | September 2, 2021 05:29 |
Questions on a pressure profile | saisanthoshm88 | Main CFD Forum | 2 | March 29, 2013 05:03 |
possible interview questions | atturh | Main CFD Forum | 1 | February 21, 2012 08:53 |
NACA0012 Validation Case Questions | ozzythewise | Main CFD Forum | 3 | August 3, 2010 14:39 |