 |
 |
 |
|
|
|
[Sponsors] | ||||
August 1, 2016, 09:04
|
Problem with transient simulation
|
#1 |
|
New Member
LZ
Join Date: Jan 2016
Posts: 3
Rep Power: 11  |
Hello, I am currently running a simulation for disc brake rotor. When I was running a transient simulation based on steady state initialization, the result looks reasonable. But if I directly run the transient simulation without initialization from the steady state, no heat transfer could be observed throughout the whole simulation. Does anyone know what should I do?
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with an old Simulation | FrankW | CFX | 3 | February 8, 2016 05:28 |
| Transient Simulation problem | mosef | STAR-CCM+ | 1 | September 10, 2014 04:34 |
| Inverse and Transient Heat Transfer Problem on commercial software: is it possible? | rogbrito | CFX | 1 | January 29, 2012 18:48 |
| Star-CD transient simulation, problem of loss of mass | kit | STAR-CD | 3 | April 13, 2010 12:34 |
| transient simulation: natural convection problem? | Basics | CFX | 3 | September 25, 2002 10:42 |
Linear Mode
