Is it a proper choice to initialize '' solid face'' in FLUENT.

oozcan · September 19, 2016, 05:05

Hi,

I am working on temperature distribution of some mould equipments.

I need to give some initial conditions for a cell zone in fluid and a face of solid zone.But I couldnt do it.

I have patched fluid cell zone by using initialization tab. But a face of solid one has not been done inspite of registering in adapt (adapt>boundary>mark)

Then I have defined that a face of solid one was chosen as ''standart initialization''.

Is it good/proper one?

Kind Regards,

LuckyTran · September 20, 2016, 17:11

Boundary conditions are applied to faces. It is improper to initialize a face.

September 19, 2016, 05:05	Is it a proper choice to initialize '' solid face'' in FLUENT.	#1
oozcan Senior Member Onur Özcan Join Date: Feb 2016 Location: Istanbul/Turkey Posts: 461 Rep Power: 12	Hi, I am working on temperature distribution of some mould equipments. I need to give some initial conditions for a cell zone in fluid and a face of solid zone.But I couldnt do it. I have patched fluid cell zone by using initialization tab. But a face of solid one has not been done inspite of registering in adapt (adapt>boundary>mark) Then I have defined that a face of solid one was chosen as ''standart initialization''. Is it good/proper one? Kind Regards,

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] mesh airfoil NACA0012	anand_30	OpenFOAM Meshing & Mesh Conversion	13	March 7, 2022 17:22
[ICEM] Error in mesh writing	helios	ANSYS Meshing & Geometry	21	August 19, 2021 14:18
Coarsening a copied face in Fluent?	emreg	FLUENT	0	June 22, 2016 03:09
[snappyHexMesh] How to define to right point for locationInMesh	Mirage12	OpenFOAM Meshing & Mesh Conversion	7	March 13, 2016 14:07
Solver settings in fluent for solid fluid both in a geometry	Prince Jassal	FLUENT	0	May 30, 2013 01:58

September 20, 2016, 17:11		#2
LuckyTran Senior Member Lucky Join Date: Apr 2011 Location: Orlando, FL USA Posts: 5,675 Rep Power: 66	Boundary conditions are applied to faces. It is improper to initialize a face.