|
[Sponsors] |
I am simulating a flow around the vibrating tube, how should I set the vibrating tube |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 19, 2024, 22:32 |
I am simulating a flow around the vibrating tube, how should I set the vibrating tube
|
#1 |
Senior Member
Join Date: Dec 2017
Posts: 384
Rep Power: 9 |
I am simulating a flow around the vibrating tube, how should I set the vibrating tube? There are three ways as below, which is right ?
1.Just set the tube wall as moving wall? 2.Set the cell zone as mesh motion with no moving wall? 3.Set the cell zone as frame motion with no moving wall? Which one is right? Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Solving Procedure of Supercritical CO2 flow in tube | erginbayrak | Main CFD Forum | 0 | August 1, 2022 09:10 |
Is recirculating flow is free vortex or forced vortex? | FluidKo | Main CFD Forum | 11 | July 21, 2022 06:21 |
unable to run dynamic mesh(6dof) and wave UDF | shedo | Fluent UDF and Scheme Programming | 0 | July 1, 2022 17:22 |
Flow of tracer in a tube | uma | FLUENT | 9 | October 3, 2003 14:53 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |