|
[Sponsors] |
Set the total number of particles using DPM (Massless) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 29, 2016, 12:27 |
Set the total number of particles using DPM (Massless)
|
#1 |
New Member
Join Date: Aug 2015
Posts: 13
Rep Power: 10 |
Dear All,
I'm running a simple pipe flow simulation (with periodic inlet boundary condition - so transient) in which I would like to release a certain amount of particles from the inlet using the Discrete Phase Model (DPM) from Fluent. I'm using the "Massless" particle type, and would like to seed to flow uniformly from the inlet with 4000 particles release every 1/50th of my time periodic signal. Could any of you be so kind to tell me how/where can I set up the amount of particles (using massless type) and also how can I control the release every Nth time? Thank you very much for your help. EmiS. |
|
Tags |
dpm, seefing particles |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar no field transfert | Jeanp | OpenFOAM Pre-Processing | 3 | June 18, 2022 12:01 |
Can you help me with a problem in ansys static structural solver? | sourabh.porwal | Structural Mechanics | 0 | March 27, 2016 17:07 |
Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 13:38 |
foam-extend_3.1 decompose and pyfoam warning | shipman | OpenFOAM | 3 | July 24, 2014 08:14 |
air bubble is disappear increasing time using vof | xujjun | CFX | 9 | June 9, 2009 07:59 |