Plunging jet air entraintment modelling with 2D- axisymmetry

503131132 · December 22, 2016, 07:05

Hello everyone,

I've been working on plunging liquid jet simulation. Before the 2D- axisymmetry, I've run just 2D calculations, and the results look very well. But now, with same boundary conditon, liquid water phase is going trought to the air inlet, I've also check the gravitational accelerition direction and magnitude but it's look not like that. Does anyone help me about this situation? Thanks.

503131132 · January 5, 2017, 01:52

Well, hello is there anyone to help me ? The problem is still existing

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Trouble modelling a jet fan	josee	OpenFOAM Pre-Processing	0	September 23, 2016 13:06
[DesignModeler] Environmental Air Modelling	oozcan	ANSYS Meshing & Geometry	2	August 14, 2016 18:52
question about the simulation of air jet into water with VOF	JU Yuanyuan	FLUENT	0	August 19, 2012 20:52
Modelling Jet Flow in a current	Adrian	FLUENT	3	January 12, 2006 10:42
Air dispersion modelling	Moied	CFX	1	May 24, 2005 18:35

January 5, 2017, 01:52		#2
503131132 New Member B.A.K Join Date: Jun 2015 Location: Ankara Posts: 6 Rep Power: 10	Well, hello is there anyone to help me ? The problem is still existing