|
[Sponsors] |
April 19, 2017, 04:39 |
Strange velocity contours
|
#1 |
New Member
Join Date: Apr 2017
Posts: 1
Rep Power: 0 |
Good morning to everyone in the forum,
I'm trying to run a 3D steady state simulation with k-epsilon realizable model and non equilibrium wall functions, and after aparent convergence, I get this strange velocity contours around the hull I'm studying, anyone has any idea why ? Thank you. |
|
April 19, 2017, 11:14 |
|
#2 |
Member
Davoud Malekian
Join Date: Jan 2016
Posts: 53
Rep Power: 10 |
Hi,
are you using parallel processing for your case? if so, do your simulation again with single processor. i think it is a graphical bug duo to do parallel processing. |
|
April 19, 2017, 21:20 |
|
#3 |
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,675
Rep Power: 66 |
If this is the cause of the problem then you have to repartition the case into a single partition. Otherwise you will run in serial mode, but still on the partitioned grid.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Velocity defect contours | lopez713 | CFX | 3 | January 5, 2016 18:58 |
[General] Paraview 4.4.0 - Problem generating velocity contours | davibarreira | ParaView | 2 | November 7, 2015 07:33 |
Strange behavior of velocity residuals | skullCFD | FLUENT | 2 | June 3, 2011 11:53 |
Strange oscillating velocity | zonexo | Main CFD Forum | 2 | April 6, 2006 11:38 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |