Home > Forums > Software User Forums > ANSYS > FLUENT

Writing UDF in ANSYS FLUENT

Mark Forums Read

Reply

Search this Thread

March 3, 2017, 06:06	Writing UDF in ANSYS FLUENT	#1
Zedd New Member Syed Join Date: Feb 2017 Posts: 6 Rep Power: 10	I want to simulate a turbine blade. However, I don't want to give rotational velocity to the blade. I want to give the inlet velocity and let the wind itself make the blade rotate. I have come across some suggestions that writing UDF is the solution. I have done some tutorials on UDF but I am unable to write. Can someone please tell me the entire UDF program for this problem??

Reply

Tags

turbine blade, udf and programming

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fluent sopenoutputfile error message	em07189	FLUENT	2	November 11, 2019 09:08
[ANSYS Meshing] negative cell volume detected while running ANSYS Fluent UDF	khushbu.bhavsar92	ANSYS Meshing & Geometry	6	April 14, 2016 16:50
sinusoidal horizontal translation udf in ansys fluent	shivshankarnair	FLUENT	1	September 19, 2014 07:40
Ansys FLUENT UDF - Velocity profile (of known values) across edge / surface	emmkell	Fluent UDF and Scheme Programming	2	October 21, 2011 14:12
Ansys FLUENT UDF - Velocity profile (of known values) across edge / surface	emmkell	FLUENT	0	October 20, 2011 08:37

All times are GMT -4. The time now is 07:03.