Home > Forums > Software User Forums > ANSYS > FLUENT

Porous jump

Mark Forums Read

Reply

Search this Thread

March 30, 2017, 06:51	Porous jump	#1
Tendai New Member tendai Join Date: Jul 2016 Posts: 2 Rep Power: 0	I am new to CFD. How do i do a 3-D simulation of a wind turbine using a porous jump. Consistently getting an error, bulk flow direction reversed. My geometry should consist of the virtual wind tunnel, and i believe the porous jump. How do it. Lost

Reply

Tags

porous jump, wind turbine

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] How can I define different zones in ICEM?	llrr	ANSYS Meshing & Geometry	14	February 12, 2017 14:44
[Commercial meshers] Porous Jump creation problem	mulfal	OpenFOAM Meshing & Mesh Conversion	4	December 9, 2013 12:59
Power extracted by porous jump	OttawaCFD	FLUENT	0	July 25, 2013 20:17
Porous Jump	Naresh	FLUENT	0	April 25, 2007 16:36
Testing the integrity of POROUS media and por jump	Azman	FLUENT	0	July 31, 2006 12:11

All times are GMT -4. The time now is 13:08.