 |
 |
 |
|
|
|
[Sponsors] | ||||
How can I keep residual under convergence |
4Likes
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 11, 2017, 09:37
|
How can I keep residual under convergence
|
#1 |
|
Senior Member
dilaw meda
Join Date: Jun 2017
Location: algeria
Posts: 145
Rep Power: 8  |
hello every one , i am using fluent to simulate an air jet in a room by the LES model , but i find it difficult to keep residual under 10^-3 . any suggestions please !!!
|
|
|
|
|
|
June 11, 2017, 14:11
|
|
#2 |
|
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,675
Rep Power: 66 |
Probably the grid quality is limiting the further reduction of residuals.
|
|
|
|
|
|
|
June 11, 2017, 14:34
|
|
#3 | |
|
Senior Member
dilaw meda
Join Date: Jun 2017
Location: algeria
Posts: 145
Rep Power: 8 |
Quote:
|
||
|
|
|
||
|
June 12, 2017, 01:36
|
|
#4 |
|
New Member
Paolo
Join Date: Jan 2017
Posts: 19
Rep Power: 9 |
Try converting the mesh in octahedral type in fluent, I think it could help and is quite quick as first attempt, if doesn't work remesh and check aspect ratio and orthogonal quality
Sent from my MotoG3 using CFD Online Forum mobile app |
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pimpleDyMFoam computation randomly stops | babapeti | OpenFOAM Running, Solving & CFD | 5 | January 24, 2018 05:28 |
| HeatSource BC to the whole region in chtMultiRegionHeater | xsa | OpenFOAM Running, Solving & CFD | 3 | November 7, 2016 05:07 |
| Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 13:38 |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |
Linear Mode
