 |
 |
 |
|
|
|
[Sponsors] | ||||
July 7, 2017, 01:44
|
Pressure adjustment
|
#1 |
|
Member
Michal
Join Date: May 2017
Posts: 35
Rep Power: 8  |
Hello there
I have to model the flow of the groundwater at the depth of 2000m. Geometry includes piece of ground between depth of 2000 and 2100m and long geothermal well reaching surface. According to data from papers, pressure there reaches about 160bar, but fluent gives much higher pressure - about 1e+11Pa as a result. Is it possible to manipulate with static pressure to achieve pressure I want? Best regards Michal |
|
|
|
|
 |
| Tags |
| conditions, geothermal, pressure, static |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind tunnel Boundary Conditions in Fluent | metmet | FLUENT | 6 | October 30, 2019 12:23 |
| Periodic flow using Cyclic - comparison with Fluent | nusivares | OpenFOAM Running, Solving & CFD | 30 | December 12, 2017 05:35 |
| Discharge of Pressure Vessel into Pipe with Regulator | gajowni2 | System Analysis | 0 | October 31, 2015 18:57 |
| Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
| Unsteady pressure differential between inlet and outlet of the pipe for single phase | joshi20h | FLUENT | 0 | September 26, 2012 12:41 |
Linear Mode
