|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Beijing
Join Date: Jul 2017
Posts: 2
Rep Power: 0 ![]() |
Hi there,
I am new to run fluent 18.0.0 in linux debian. I have installed fluent 18.0.0 on the machine with user account, and set up ssh no password. but when I run the command below: fluent -g 3d -t4 It ends up with the following output: /home/dawei/fluent/v180/fluent/fluent18.0.0/bin/fluent -r18.0.0 -g 3d -t4if "3d" was typed here, a fluent without parallels can be launched. I don't know what is wrong with mpi!? |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
looking for a smart interface matlab fluent | chary | FLUENT | 24 | June 18, 2021 09:07 |
Interesting problem: Parallel Processor VOF Fluent + Dynamic Mesh + System Coupling | spaceprop | FLUENT | 5 | September 2, 2014 09:43 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
fluent convergence problem | josip76 | FLUENT | 0 | May 26, 2011 20:08 |
Problems with FLUENT MPI on i7 2600K/P8P67 | TaurusASV | FLUENT | 1 | May 5, 2011 11:58 |