|
[Sponsors] |
Segmentation fault on PEMFC model addon/ Ansys Fluent |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Ryan Lee
Join Date: Jul 2017
Posts: 10
Rep Power: 9 ![]() |
hello, everyone.
This is Ryan Lee. I want to ask some questions about the PEMFC model in Fluent. I am following the instruction from the ANSYS official overvie on Youtube. But many errors appear during process. For now I made the mesh for single channel PEMFC and loaded PEMFC model on Fluent software. I saw 2 errors. 1. Error: GENERAL-CAR-CDR: invalid argument [1]: improper list Error Object: #f 2. Error: received a fatal signal (Segmentation fault). Error Object: #f For error 1, it shown up when I specify parameter at the model. when I click ok, it appeared. I heard that if I set all parts as fluid material, i can avoid the error. So after setting all geometry as fluid, it didn't appear further. But after finishing setting boundary condition up and then running the calculation, error 2 shown up. And there were no results about the run. Do you have any idea about the error 1 and 2? And 1 more question, for the anode and cathode flow channel, I made hexahedron geometry, not just face. And set as flow channel zone. Is this right way to do that? Thank you in advnace. I am very new about Ansys. Please understand my not enough knowledge. |
|
![]() |
![]() |
![]() |
Tags |
ansys, fluent, pemfc |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
3d pemfc model - fluent module & gambit - error | meisam | FLUENT | 10 | February 14, 2018 16:47 |
Segmentation Fault 11 Running simpleFoam with new turbulence model | Jack001 | OpenFOAM Running, Solving & CFD | 3 | June 24, 2015 13:29 |
[ANSYS Meshing] Convert 2D model to 3D one in ANSYS Fluent | saharesobh | ANSYS Meshing & Geometry | 0 | November 25, 2013 16:57 |
Exporting fluent melting/solidification model results to ansys mechanical apdl | omair11 | ANSYS | 3 | August 28, 2013 06:22 |
Launching Fluent: Segmentation fault | gravis | FLUENT | 3 | October 23, 2010 09:41 |