 |
 |
 |
|
|
|
[Sponsors] | ||||
sampling pressure at one point in unsteady simulation |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 17, 2017, 13:01
|
sampling pressure at one point in unsteady simulation
|
#1 |
|
Member
Join Date: May 2017
Posts: 41
Rep Power: 8  |
Hi,
I am doing an unsteady simulation. I would like to know how I can sample pressure at one point in my domain and write the values to the output file during the simulation (pressure signal vs time). Later I would like to perform FFT on the obtained signal or perhaps get the RMS. Any ideas what is the best way to do this? Thanks a lot. |
|
|
|
|
|
| Tags |
| fluent, monitor, probe, rms, signal |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Facing a floating point error when reducing time step in a unsteady simulation | withwolf | STAR-CCM+ | 7 | November 14, 2018 19:38 |
| Problem with an old Simulation | FrankW | CFX | 3 | February 8, 2016 04:28 |
| sonicFoam - pressure driven pipe: flow continuity violation and waveTransmissive BC | Endel | OpenFOAM Running, Solving & CFD | 3 | September 11, 2014 16:29 |
| block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
| Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 15:00 |
1Likes
Linear Mode
