 |
 |
 |
|
|
|
[Sponsors] | ||||
Automaically changing of Cell zone name in fluent |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 17, 2017, 09:29
|
Automaically changing of Cell zone name in fluent
|
#1 |
|
New Member
Join Date: Oct 2017
Posts: 1
Rep Power: 0  |
hi there,
this is what happened..! Once upon a time the whole fluent has been setup and the results have been acquired. I close the fluent and opened the CFD post ( results were ok  , so, let it calculate for some more time to get good results ). Then I open my fluent to simulate further, one of the cell zone is changed automatically and the parameters that I have set are gone  ( poof gone, just like that).So, do you have any idea about that  . please haalp.. |
|
|
|
|
|
| Tags |
| cell zone, fluent |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building problems with cell zones when reopening Fluent | MJ2017 | FLUENT | 0 | October 14, 2017 09:11 |
| Journal file error | magicalmarshmallow | FLUENT | 3 | April 4, 2014 13:25 |
| The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 23:56 |
| Input Temperature data in a 3D geometry by .Prof file in cell zone in fluent | enayath | FLUENT | 0 | November 6, 2013 23:12 |
| Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 22:58 |
Linear Mode
