 |
 |
 |
|
|
|
[Sponsors] | ||||
December 24, 2017, 15:49
|
Patch an elliptical zone in VOF method
|
#1 |
|
New Member
Mohammad Sobhani
Join Date: Sep 2012
Location: Iran, Tehran
Posts: 8
Rep Power: 13  |
Dear friends,
I want to simulate falling of an elliptical droplet of water in air via VOF method. How can I adapt an elliptical region? |
|
|
|
|
|
December 24, 2017, 21:43
|
|
#2 |
|
New Member
Alex
Join Date: Dec 2017
Posts: 13
Rep Power: 8 |
It seems that you can't adapt an elliptical region in fluent, while there are only sphere and hex and cylinder options. Maybe you can define this region as a new domain when you are doing meshing , then you can patch the different domains. I haven't done this before, but I think you can give it a try.
|
|
|
|
|
|
 |
| Tags |
| vof multiphase |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Near wall treatment in k-omega SST | Arnoldinho | OpenFOAM Running, Solving & CFD | 38 | March 8, 2017 13:48 |
| [Commercial meshers] Problems with ANSYS mesh conversion | tdog | OpenFOAM Meshing & Mesh Conversion | 1 | March 31, 2016 17:36 |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
| [ICEM] Export ICEM mesh to Gambit / Fluent | romekr | ANSYS Meshing & Geometry | 1 | November 26, 2011 12:11 |
| Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
Linear Mode
