Interior wall

yuweng · February 28, 2018, 10:59

Hi,
I have simulated a left ventricle flow and have put and interior geometry to act as a valve. The problem arises when this interior geometry is defined as a wall boundary condition but the flow still goes through it.
It seems like this interior geometry is ignored.
Can someone help me solve this problem?
Thanks beforehand

CeesH · March 5, 2018, 09:54

"interior" means the geometry is set to be transparent to flow. Go to boundary conditions and change from interior to wall, and all should work.

February 28, 2018, 10:59	Interior wall	#1
yuweng New Member Join Date: Feb 2018 Posts: 1 Rep Power: 0	Hi, I have simulated a left ventricle flow and have put and interior geometry to act as a valve. The problem arises when this interior geometry is defined as a wall boundary condition but the flow still goes through it. It seems like this interior geometry is ignored. Can someone help me solve this problem? Thanks beforehand

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

March 5, 2018, 09:54		#2
CeesH Senior Member Cees Haringa Join Date: May 2013 Location: Delft Posts: 607 Rep Power: 0	"interior" means the geometry is set to be transparent to flow. Go to boundary conditions and change from interior to wall, and all should work.