 |
 |
 |
|
|
|
[Sponsors] | ||||
March 21, 2018, 10:10
|
quenching tanks
|
#1 |
|
New Member
jose antonio guzman santana
Join Date: Dec 2017
Posts: 7
Rep Power: 8  |
I'm new in this forum, my greatest congratulations to the creators of the forum. My question is:
Im creating a quenching tank in 3d of 8x8x4 meters. as you can see is a very large simulation. I'm planning to make it on a 2d design. but in this design the solution doesnt converge. What Im doing is, putting a multiple inlet velicity correspondign to the agitators in the bottom surface and what i dont know is weather I have to put an outlet at the surface of the water or not. What do you think |
|
|
|
|
 |
| Tags |
| heat treatment, steady simulation, tank filling |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Equalizing Pressure between Two Tanks | cwl6750084 | FLUENT | 6 | April 14, 2020 06:39 |
| k-epsilon model for stirred tanks | Parag Shah | Main CFD Forum | 3 | June 22, 2013 15:24 |
| heat transfer coefficient in quenching process | mechanical | AVL FIRE | 3 | August 9, 2012 10:44 |
| Water quenching with impinging jets | Rockda | Main CFD Forum | 1 | September 6, 2010 23:20 |
| Flame quenching | Xu Zhou | Main CFD Forum | 1 | September 23, 1999 11:18 |
Linear Mode
