|
[Sponsors] |
April 14, 2018, 06:08 |
Can not create a volume to analyse in fluent
|
#1 |
New Member
Emirhan
Join Date: Apr 2018
Posts: 1
Rep Power: 0 |
As you you can see in below, i have an geometry which mimics the room. I want to blow air from bigger hole and vacuum the old air in the room from other two little holes. To analyse this i need to create a volume inside this room but i cant.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Meshing a Sphere | Ajay | FLUENT | 10 | September 3, 2016 14:18 |
[blockMesh] Errors during blockMesh meshing | Madeleine P. Vincent | OpenFOAM Meshing & Mesh Conversion | 51 | May 30, 2016 10:51 |
[blockMesh] Include list of points | Hikachu | OpenFOAM Meshing & Mesh Conversion | 0 | June 20, 2011 09:03 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
How to create different zones in a 3-D volume. | Tonmoy Roy | FLUENT | 5 | February 28, 2004 11:47 |